WINDOWS 2000 SETUP SHEET
Check wire configuration in the computer, (jumpers, primary master, secondary master)
Boot up and get on the bios by pressing delete, change it so that it boots off the CD rom not the floppy, then change primary, and secondary
Primary master type: auto P10: - 32 bit: On
Secondary master Cdrom Auto On
F10 to save
Once you come out of the Bios, reboot, and then put cd in immediately
Setup will first load files into ram
The last two are the most important files
Press enter when its finished
F8 to agree
Esc-don't repair
Hit D for delete partition
Enter to continue with deletion
Press l to delet
Hit enter to setup partition in the space
Format the partition using the NTFS file system
If message comes up that you cannot copy a file, retry atleast once, the get a diferent cd, then retry again
When it reboots on its own, take the disk out, then shut it back down
Start back up and put the disk in at the windows 2000 loading screen
It will then start installing the devices
Regional settings- click next
Name - Ganado ISD, next
Computer name GISD#, next
time zone- central, next
Network settings- typical , next
Workgroup-no, GANADOISD, yes, then click no, next
Installs components
Final tasks
Finishes, reboot, take disk out
When it comes up don't put a password just click ok
The 1st thing you check is video, go to properties on the desktop, Pixels 800 by 600, true color 32 bit, apply
Next you check the nic by going to device manager by right clicking my computer, properties, go to hardware, device manager.
English: CD ROM Русский: Устройств...
dilo december 2005 - Zijn er files?
NeXT CD-ROM drive